Customise your snowboard

Application of Tattoboards for customise snowboards is simple.
Just remove bindings, clean the snowboard from all dirt particles and finally apply Tattooboards carefully.

After having affixed Tattoboards correctly to your snowboard, trim the edges of the sticker with a cutter along the profile of your snowboard, as Tattooboards is sent to you in rectangular form with 1 cm of margin (see picture).

Follow the pictures´s instructions

After having removed the bindings and cleaned the surface of your snowboard with alcohol, continue as follows:

Firstly, remove the protective film and cut it in the middle (1, 2) Press both ends on Tattooboards again (3). Position Tattoboards as precisely as possible over your snowboard (4).
Once your are sure of having correctly positioned the sticker over your snowboard, press one side of it firmly on the board, remove the protective film (5) and proceed very carefully by using the application tool sent with the kit (6, 7, 8).
Proceed with the second part in the same way (9, 10, 11, 12).
Cut the edges with a cutter (using a new blade) (13, 14).
Remove the application tape and trim the contours to fit your snowboard. (15, 16, 17, 18).

Useful advice:

Clean your snowboard very carefully before starting the application and make sure the board is dry;
Work in a bright, clean and comfortable place;
Before starting the application make sure that Tattoboards is perfectly positioned over the snowboard;
Use the application tool;
Make sure it adheres completely on the board´s margins;
Trim jutting edges by using a cutter with a new blade;
Make sure you´ve trimmed Tattoboards as much as possible by slanting the cutter towards the centre of the board;

Don´t rush it!

Customise your snowboard: How to apply Tattooboard